|
| Cool-Tape Plus TM 2'' x 60' |
Cool-Tape consists of a 1 mil aluminized material bonded to a light weight, woven fiberglass with super strong adhesive backing and release liner. Cool-Tape can reflect up to 1500 degrees of radiant heat. The uses are limited only by your imagination but common uses include wrapping wires or fuel lines and sealing openings in floor boards or firewalls. This is the finest heat shielding tape on the market Up to 1500 degree protection More flexible Strong adhesive Thin for a tight wrap
|
| |
| This item usually takes about 2 days to ship |
| |
| Item no. 10413 |
Retail: $71.40 (PLUS shipping) |
| Today's Sale Price: $66.98 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DEI Cool Tape™ FAQ
How much heat can the tape withstand?
Cool tape can withstand over 2000 degrees radiant heat.
How thick is the tape?
Cool Tape is about 4mil thick.
Do you make the tape in a larger size?
Our Reflect-A-Cool material is a larger version of the Cool Tape and offered in a 48" x 36” sheet. Currently, Cool Tape is offered in 3 different sizes, 1-3/8" x 15' roll (PN # 10408), 1-3/8" x 30' roll (PN # 10416), and 2" x 60' roll (PN # 10413).
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: You mention that "This tape will work as long as there is an air gap". My question is, Is there a minimun distance gap to work properly? I'm looking into aftermarket fairings and was thinking of linining the entire inside of the fairings with this product and I know the lowers are VERY close to the exaust pipe. Thank you for your time! |
| ANSWER: Reflective aluminum is most effective with a 3/4 inch air space. |
|
| QUESTION: I have a high mount exhaust and it is really close to my carbon fiber exhaust and it gets really hot. cna i use this tape to protect my plastic in the small area where its too close, so i wont melt the plastic? |
| ANSWER: This tape will work as long as there is an air gap - it will NOT work if it is touching the hot surface. If applied carefully to a clean surface (clean with rubbing alcohol) it should be cosmetically acceptable. This may be the best possible solution for the application you describe. If you were to wrap the pipe with heat wrap it would probably fill the small gap causing it to touch, and would not look good. Protecting the plastic with a radiant barrier is the correct solution. |
|
| QUESTION: dumb question for you from a newer sport bike rider. Can I use this product to wrap the exhaust from the headers back to help reduce the heat that I can feel on my legs and reduce the temp with my undertail exhaust? Thank you Robert |
| ANSWER: You should use exhaust wrap for this. |
|
| QUESTION: Hi: Does the foil face in or out? Thanks. Chris |
| ANSWER: This is an actual roll of tape. Sticky on the inside, foil on the outside. |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Photos
powered by