|
| -TiteLite- Auto License Plate Light Kit - Domed Head Polished Finish |
TiteLite License Plate Light kits feature a right-angle LED for direct illumination of your license plate. Super bright LEDs are extemely efficient and emit a higher degree of light in a desired location than incandescent lamps. Since there is no filament that can be damaged, LEDs are incredibly durable - virtually shock and vibration-proof!
The clear epoxy covered lens offers waterproof protection.
Temperature resistant
Low power consumption
Low heat output
No damaging UV emissions
Kit contains 2 lights for the top and two bolts for the bottom.
 |
| |
| Item no. 030309 |
| This item is currently not available for sale. This page is made available for informational purposes only. |
|
|
|
|
|
|
|
|
|
|
|
|
|
Domed Head Style bolts with a notch machined into the head and a light bulb installed to illuminate at a 90 degree angle.
Machined from top quality Stainless Steel the great little lights will find many uses in your motoring world. Designed to used as a license plate light when the stock light has been lost due to modifications.
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: I need this to go through the license plate, the license plate holder, and a cutting board (stops the plate from vibrating). How long are the threads on these? |
| ANSWER: The threads are 3/4" long. |
|
| QUESTION: I have tryed to install six of these on my plate but they keep blowing my fuse. What would the problem be? Do I need a load equalizer? I have one for my turn signals. |
| ANSWER: These units only draw 30 mA, so the entire load is on the order of 180 mA with 6 units. There has to be a flaw in your wiring that is creating a short, or the units are not wired in parallel so that each unit gets 12 volts - no series voltage drops are allowed. also, red wire is positive and black is common. |
|
| QUESTION: do these have to be hard wired in ? how do the lights get power? |
| ANSWER: You will hard wire them to the existing license plate light wiring. |
|
| QUESTION: Item no. 030309 Tite Light - You picture two styles of this light. One is cone shaped the other is a blunt top. How do I differentiate them when ordering? |
| ANSWER: This one is dome shaped. The other style is called "acorn". |
|
| QUESTION: What are the installed heights for these two lights? |
| ANSWER: These lights are 1/2" tall. |
|
|
Event Photos
powered by
